Need help?Do you have a question about the Tecnoma Novatec Isobus and is the answer not in the manual?
Defines the intended use of sprayers and manufacturer's liability.
Highlights important safety measures and the need to read the handbook before use.
Explains how functions are activated and represents icons for functions.
Provides descriptions for various symbols and their corresponding functions or actions.
Details various settings pages for machine data and configurations.
Details settings for Dose, Nozzle, Boom width, Wheel, Regulation factor, and Pressure.
Covers settings for Tank volume, Warning level, Pulse Flow, and Pulse return.
Details settings for section control, filling mode, joystick operation, and circulation type.
Details the sequential mode for opening and closing the boom, including actions and screen displays.
Explains the simultaneous mode for boom opening/closing using independent controls.
Details hydraulic functions controlled by the joystick and their corresponding LED colors.
Describes how to view spraying data like volume, speed, and calculated pressure.
Guides users through programming the desired application dose in litres per hectare.
Explains how to select the desired boom width from the settings page.
Guides users on how to select the appropriate mounted wheels for the job.
Explains how sections are represented and how to select or open them.
Details how to open/close sections using the joystick, including switch positions and LED indicators.
Explains how to open/close sections using the terminal, including settings changes and screen access.
Describes how to adjust dose up or down by rate using the screen or joystick.
Explains how to select and spray individual sections.
Details cursor movement and section selection/O/C using the joystick.
Explains how to activate directional mode via settings and the terminal.
Shows how to view the current tank volume and filling status.
Guides on using the autonet option for tank filling and rinsing cycles.
Details how to manually input the number of pulses for speed calibration.
Shows the screens involved in calibrating the automatic boom height function.
Explains how to activate and use the automatic boom height function.
Guides through the calibration procedure for the tag axle, including manual displacement steps.
Explains how to use the tag axle in automatic and manual modes.
Details calibration and use of automatic super-elevation correction with steering axle.
Explains the importance of nozzle choice for accurate pressure calculation and regulation.
Details the step-by-step procedure for calibrating standardized and non-standardized nozzles.
General| Brand | Tecnoma |
|---|---|
| Model | Novatec Isobus |
| Category | Control Unit |
| Language | English |
To Next Page
