12
14
13
FOLLOW ME Button
Push this button to initiate the Follow Me
feature, the remote display actual
temperature at its location. The remote
control will send this signal to the air
conditioner every 3 minutes interval until the
Follow Me button is pressed again. The air
conditioner will cancel the Follow Me feature
automatically if it does not receive the signal
within any 7 minutes interval.
LED Button
Disable/Active indoor screen Display. When
pushing the button, the indoor screen display
is cleared, press it again to activate the
display.
LCD Display
Fan speed indication
Mode display
Information are displayed when
the remote control is powered up.
Displayed when data is transmitting.
Displayed when remote controller is ON.
Battery display (low battery detection)
Low speed
Medium speed
High speed
Auto fan speed
Note:
All indicators shown above are for presentation
purpose only. During the actual operation only the
active indicators are shown on the display window.
Displayed when TIMER ON time is set.
Displayed in SLEEP Mode operation.
Indicated that the air conditioner is
operating in FOLLOW ME mode
Displayed when TIMER OFF time is set.
Show set temperature or room
temperature, or time under TIMER
setting.
AUTO
HEAT FAN
COOL DRY
5
6
Features
MMOODDEE
FAFANN
TTEEMMPP
SSLLEEEEPP FFRREESSHH
LLEED D FFOOLLLLOOW W MMEE
TTUURRBBO O SSEELLF F CCLLEEAA NN
OONN//OOFFFF
TTIIMMEERR
OONN
TTIIMMEERR
OOFFFF
11
22
44
55
33
99
1010
88
66
77
1111
1212
1313
1414
C
11
TIMER OFF Button
Press this button to initiate the auto-off time
sequence. Each press will increase the auto -
timed setting in 30 minutes increments.
When the setting time displays 10H, each
press will increase the auto-timed setting
60 minutes increments. To cancel the auto-
timed program, simply adjust the auto-off
time to 0.0H.
Swing Button
Used to stop or start auto swing horizontal louvre
movement or set the desired up/down air flow
direction. The louvre changes 6 degree in angle
for each press. If pressed for more than 2
seconds, the louvre will swing up and down
automatically.
Swing Button (For 3D DC Inverter Series Only)
Used to stop or start auto swing feature of
vertical louvre movement or set the desired left
right air flow direction. The vertical louvre
changes 6 degree in angle for each press. If
pressed for more than 2 seconds, the louvre will
swing left and right automatically.
To Next Page
Loading...