TECO TC 20 - Resetting Chiller

1
2
3
4
5
6
7
8
• Plug in and turn on the chiller
• At the top of the control panel, above the display and
controls are a series of small metal prongs. Remove
the plastic ‘jumper’ from prongs 1-2 or 4-5.
• Place jumper on pins 7-8 momentarily.
• Remove jumper from pins 7-8.
• Replace the jumper to its original location.
• Now turn off your chiller.
Note: Resetting your chiller will change your set
temperature back to the default of 23°C.
CAUTION: Leaving chiller on for extended periods of time with
no water flowing will cause the unit to overheat.
UV Jumper
(Position may vary depending on whether UV is installed
- shown in the “no UV position”)
Heater Jumper
(Position may vary depending on whether heater is installed
- shown in the “no Heater position”)
Resit Pins
( Place jumper here
momentarily to Reset )
S tep 3
Resetting Chiller
Front
of
Chiller