STEP n.
5
www.tecoonline.com | www.tecous.com
Reassemble the chiller: place the metal cover of the chiller in its
own place and don’t foget to connect ground wire to metal fairing
Connect chiller to power supply
Turn on the chiller for 5 seconds, then turn it off
Disconnect the chiller from power supply
Dismount the metal cover (step 1 and 2)
Move the jumper from Reset pins to its original position (you took
a picture in step.3 to rmemeber jumper position).
Reset pins will be free (without jumper).
To Next Page
Loading...
