TECO TWW40HFCG - ON;OFF and MODE Button Operations; +;- Button Operation

Name & FuncƟon of Wireless Remote Control
(Not applicable to TWW16CFCG)
Remote Control
Note:
When power is connected(stand by condition), you can operate the air conditioner
through the remote controller.
When unit is on, each time you press the button on remote controller, the sending
signal icon " "on the display of r emote controller will blink once. If the air
ditioner gives out a beep sound, it means the signal has been sent.
When unit is off, set temperature will be displayed on the remote controller (If the
light of indoor unit display is turned on, the corresponding icon will be displayed);
When unit is on, it will display the icon of the on-going function.
1
ON/OFF button
Press this button to turn unit on/off.
2
MODE button
Pressing this button once can select your required mode circularly as below (the
corresponding icon "
" will be lit up after the mode is selected):
AUTO
COOL
DRY
FAN
HEAT
When selecting auto mode, air conditioner will operate automatically according to
ambient temperature. Set temperature can't be adjusted and won't be displayed
either. Press FAN button to adjust fan speed.
When selecting cool mode, air conditioner will operate under cool mode. Then
press + or - button to adjust set temperature. Press FAN button to adjust fan speed.
When selecting dry mode, air conditioner will operate at low fan speed under dry
mode. In dry mode, fan speed can't be adjusted.
When selecting fan mode, air conditioner will operate in fan mode only. Then
press FAN button to adjust fan speed.
When selecting heat mode, air conditioner will operate under heat mode. Then
press + or - button to adjust set temperature. Press FAN button to adjust fan speed.
(Cooling only unit can’t receive heating mode signal. If set HEAT mode by remote
controller, press ON/OFF button can’t turn on the air conditioner.)
When in HEAT mode, the operation may stop from time to time to perform
defrost function. during defrost H1 will be displayed. See page 16
3
+ / - button
Pressing + or - button once will increase or decrease set temperature by 1°F(°C).
Hold + or - button for 2s, set temperature on remote controller will change quickly.
Release the button after your required set temperature is reached.
When setting Timer On or Timer Off , press + or - button to adjust the time.(See
TIMER Button for setting details)
13
con