16
Operation Tips
Changing the remote controller batteries
Notes
Press the remote controller back cover downward
while sliding the cover in the direction of the arrow.
Remove the exiting batteries.
Insert two new AAA 1.5V batteries. Ensure the batteries
are inserted in the correct direction as in the image to
the right.
Replace the back cover once the batteries are securely
in place.
• When changing the batteries, do not mix new and old batteries.
Do not mix brands or battery types.
• If the remote control is not used for long periods, remove the
batteries to reduce the chance of leakage and damage to the
remote.
• The remote has a limited range. This range reduces over time as the batteries
lose charge.
• When using the remote, keep away (>1M) from other wireless appliances.
• When the remote does not operate, remove the batteries, wait 30sec. and
replace them. If problems persist, replace with new batteries.
CAUTION
Opera on in hea ng mode
•
The amount of hea ng provided in HEAT mode will vary depending on
environmental condi
ons exis ng at the me of opera on.
Performance is dependent on the amount of heat available in the outside air
and the output heat capacity of the machine compared to the size of the
space being heated.
Heat absorbed by the outside heat exchanger (coil) will be reduced by frost
buildup dependent on the amount of moisture in the outside air entering
the machine.
From
me to me the microcomputer will stop the hea ng opera on to
defrost the outside heat exchanger, during this process some noises may be
apparent when the opera
on is reversed.
During defrost,
H1
will be displayed, hea ng func on will resume in short
me. This func on is normal and not a fault. Please do not turn off Unit.
•
•
•
•
signal sender battery
Cover of battery box
remove
reinstall
To Next Page
Loading...
