InstallaƟon
Teco Australia Pty Ltd does not warrant the equipment supplied by Teco Australia Pty Ltd, will as installed, comply
with the Building Code of Australia or any other similar standard or code. The customer/contractor is solely
responsible for ensuring that the equipment installed complies with any relevant code or standard.
IMPORTANT NOTICE
Due to various wall and window types and construcƟons, Teco Australia Pty Ltd recommends the window/wall
type room air condiƟoner must be installed with compliance to the Building Code of Australia, Local Government
or body corporate requirements. Please consult your local builder or air condiƟoning contractor.
All hardware required to install the air condiƟoner is Įeld supplied.
Drainage
To get the maximum cooling eĸciency, the
air condiƟoner is designed to splash the
condensaƟon water on the condenser coil.
The cooling & heaƟng model has a
thermostaƟcally controlled drain mechanicism.
The drain will open <14
o
C (approx.) to allow
water to Ňow from the base of the unit and will
close >15
o
C (approx.).
WARNING:
Do not push any object into the condensate
drain hole as it may damage the condensaƟŽn
water thermostat mounted above.
The cooling only models, If the splashing sound annoys you, you can provide an outside drain by using the
following procedure, which may however cause a small loss of performance.
If a drain is required, please follow the steps below.
1.
Slide out the chassis from the cabinet.
2.
Remove the rubber plug from the body base plate.
3.
Install the drain pan to the corner of the cabinet with 2 screws.
4.
Connect the drain hose (Įeld supplied) to the outlet on the drain pan boƩom.
5.
Slide the chassis into its original place inthe cabinet.
Tilt
When installing the unit, to clear condensate
from the unit, the back edge of the cabinet
should be approximately 6mm lower than the
front edge.
8
To Next Page
Loading...
