TECO TWW53HFWDG - Remote Control Panel Overview; Model-Specific Controls; Ventilation Lever Operation

Control Panel
2
1
5
6
Cooling Only
Models
3
4
4
7
Cooling &
Heang Models
2
1
5
6
3
4
4
7
1
5
6
POWER BUTTON
Operaon starts or stops when this buon is pressed
SWING BUTTON
Acvate the automac air swing funcon
FAN SPEED BUTTON
Select the fan speed HIGH, MID, LOW and AUTO in sequence.
TIME/TEMP BUTTON
SIGNAL RECEIVER
MODE BUTTON
Select the operaon mode, AUTO, HEAT,
COOL, FAN, DRY (for reverse cycle model)
or AUTO, COOL, FAN, DRY (for cooling only
model).
FILTER BUTTON
This feature is a reminder to clean the Air
Filter (see Care & Cleaning). The LED light
will illuminate aer 250 hours operaon. To
reset aer cleaning the filter, press the Filter
buon and the light will go off.
If the filter requires cleaning prior to the
250 hours of operaon, remove, clean and
replac
e the filter. To reset the mer, press
the Filter buon for at least 3 seconds and
the accumulated me of operaon will be
cancelled.
2
3
4
7
Press the
keypad to increase the set (operang)
temperature of the unit and press the
keypad to
decrease the set (operang) temperature of the unit.
The temperature seng range is from 16
o
C~30
o
C
Press the
keypad also to increase the selected me
in 1 hour increments and pressing the
keypad to
decrease the selected me in 1 hour decrements.
Venlaon Lever
CLOSED VENT OPEN
CLOSED VENT OPEN
Open Posion:
The venlaon door opens
to allow air and to be
expelled from the room.
Closed Posion:
The venlaon door is
closed and the air will be
circulated inside the room
and condioned.
12
odors