TECO TWW60CFCG - Control Panel Overview; Cooling Only Models Controls; Cooling & Heating Models Controls

Control Panel
2
1
5
6
Cooling Only
Models
3
4
4
7
Cooling &
HeaƟng Models
2
1
5
6
3
4
4 7
1
5
6
POWER BUTTON
OperaƟon starts or stops when this buƩon is pressed
SWING BUTTON
AcƟvate the automaƟc air swing funcƟon
FAN SPEED BUTTON
Select the fan speed HIGH, MID, LOW and AUTO in sequence.
TIME/TEMP BUTTON
SIGNAL RECEIVER
MODE BUTTON
Select the operaƟon mode, AUTO, HEAT,
COOL, FAN, DRY (for reverse cycle model)
or AUTO, COOL, FAN, DRY (for cooling only
model).
FILTER BUTTON
This feature is a reminder to clean the Air
Filter (see Care & Cleaning). The LED light
will illuminate aŌer 250 hours operaƟon. To
reset aŌer cleaning the Įlter, press the Filter
buƩon and the light will go oī.
If the Įůter requires cleaning prior to the
250 hours of operaƟon, remove, clean and
replace the Įlter. To reset the Ɵmer, press
the Filter buƩon for at least 3 seconds and
the accumulated Ɵme of operaƟon will be
cancelled.
2
3
4
7
Press the keypad to increase the set (operaƟng)
temperature of the unit and press the
keypad to
decrease the set (operaƟng) temperature of the unit.
The temperature seƫng range is from 16
o
C~30
o
C
Press the keypad also to increase the selected Ɵme
in 1 hour increments and pressing the keypad to
decrease the selected Ɵme in 1 hour decrements.
VenƟůaƟon Leve
r
CLOSED VENT OPEN CLOSED VENT OPEN
Open PosiƟon:
The venƟlaƟon door opens
to allow air and to be
expelled from the room.
Closed PosiƟon:
The venƟlaƟon door is
closed and the air will be
circulated inside the room
and condiƟoned.
11
odors