TecTake 400990 - Cleaning and Maintenance; Cleaning Procedures; Technical Data; Noise Information

Attention: Plastic parts are best routed at low speeds!
Do not store the tool until it has completely stopped.
Do not store in dusty places. Dust can get into the machine everywhere and cause the
mechanical parts to malfunction.
8. CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
8.1 Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth
, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
Voltage
230V ~
Mains frequency
50 Hz
Power
1200W
No load speed
11.000-30 000 min
-1
Cutting depth
35 mm
Spindle diameter cutter
8 mm
Weight
3.3 kg
Protection Class
II
Double insulated
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
86 dB(A)
Acoustic power level LwA
97 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration)
6,23 m/s²
K = 1,5 m/s²
9. TECHNICAL DATA
10. NOISE
7