To Next PageTo Next Page
Need help?Do you have a question about the Tecumseh LAV40 and is the answer not in the manual?
Locating and interpreting Tecumseh engine model, serial, and DOM numbers.
Proper selection and use of engine oil for Tecumseh engines.
Diagnosing engine performance issues related to restricted or oil-soaked air filters.
Procedures to identify dual system, Series 1, Series 3/4, and diaphragm carburetors.
Flowchart for diagnosing engine starting problems.
Chart to diagnose engine problems based on air, diaphragm, and fuel system issues.
Procedure for adjusting main and idle mixture screws for optimal engine performance.
Step-by-step guide for disassembling float style carburetors.
How to check and adjust the float height for proper carburetor operation.
Diagnosing engine problems suspected to be related to the governor system.
Procedures for diagnosing and correcting engine overspeed conditions.
Steps to diagnose and correct engine RPM surging or hunting.
Procedures for governor adjustment and setup.
Method for adjusting the governor clamp on the governor lever.
Procedures for removing and replacing governor spool, gear, or shaft.
Adjusting high and low speed RPMs on medium frame vertical engines.
Overview of engine electrical systems: battery, starting, and charging circuits.
A flowchart to diagnose starter circuit problems when the engine won't turn.
A flowchart to diagnose electrical charging circuit issues.
Checking the system for 350 milliamp charging systems, including voltage tests.
Checking the 5 Amp alternator system with regulator-rectifier under blower housing.
Checking the 10 Amp alternator system with external regulator-rectifier.
Testing voltage regulators using a voltmeter to ensure proper battery charging.
Checking the function of low oil shutdown switches and ignition modules.
Operation of inside edge flywheel brake systems that ground the ignition.
Service procedures for flywheel brake systems that fail to stop the blade.
Service procedures for bottom surface and inside edge brake lever and pad assemblies.
Checking and replacing the starter interlock switch for safety engagement.
Overview of Tecumseh ignition systems: solid state CDI and magneto.
How solid state CDI and magneto ignition systems generate spark for ignition.
Flowchart for diagnosing engine ignition problems like no spark or erratic running.
Steps for testing spark, plugs, ignition timing, and magnets.
Procedures for cleaning, gapping, and replacing spark plugs.
Importance of correct ignition timing for engine performance and power.
Setting ignition timing for solid state systems using air gap gauges.
Explanation of the 4-cycle engine theory: intake, compression, power, exhaust strokes.
Detailed explanation of the four strokes of an internal combustion engine cycle.
Troubleshooting guide for common engine operational issues like knocks and overheating.
Procedures for testing engine knocks, overheating, surging, and misfires.
Diagnosing and resolving engine knocking issues.
Troubleshooting steps for engines that overheat due to loading or airflow issues.
Step-by-step guide for disassembling the engine.
Proper procedures for removing and installing oil seals.
Torque specifications for various engine components across different models.
General
