The TeeJet BoomPilot interface communicates with the Amatron via the Amaclick protocol using the same CAN bus-id. The Amaclick
and the BoomPilot interface cannot be connected at the same time.
AMACLICK is an optional ergonomic CAN bus switch box, typical used in special crops which often require manual on/off control of the
individual sections. When the BoomPilot interface is connected, manual on/off control of the individual sections must be done via the joy-stick
or Amatron.
Figure 2: Possible combinations
Amatron+
Amatron-3
TeeJet BoomPilot
Interface
Amatron+
Amatron-3
TeeJet BoomPilot
Interface
Amazone
Joy-stick
Amatron+
Amatron-3
TeeJet BoomPilot
Interface
Amazone
Amaclick
Amatron+
Amatron-3
TeeJet BoomPilot
Interface
Amazone
Joy-stick
Amazone
Amaclick
A
B
C
D
To Next Page
Loading...