Owner’s manual 13
EN
BEFORE FIRST USE
OPERATION
Carry on a few toasting cycles without any bread inside the toasting slots to
remove any production residues and preheat the new elements. During this
process, the appliance may release an odor. This is a normal reaction and
should not reoccur.
1. Insert a slice of bread into each of the toasting slots.
2. Make sure the crumb tray is installed in place.
3. Plug the power cord to the power supply socket.
4. Set the browning control knob to the desired position (1 = light;
7 = dark).
Hints:
•Set to middle position to toast the bread to golden color.
•Toasting color for one slice is darker than that for two slices at the
same level.
•If toasting continuously, toasting color for the latter bread slice is
darker than that for the previous slice at the same level.
5. Press down the lever until it latches in place (the lever can only latch
when the appliance is connected to power mains). The Cancel button
backlight will turn on.
6. Once the bread is toasted to the preset browning degree, it will
automatically pop up.
•You can also observe the toasting color during operation. When it
is satisfactory, press the Cancel button to stop toasting- the toasts
will pop up.
If smoke starts to emit from the toaster, press the Cancel button to stop
toasting immediately!
To Next Page
Loading...