STEP 4
Connect Adapter
• Secure the controller cord and electrical cord from the Vibration
Cushion to the rear leg of the A-frame using the Velcro strap
provided (Figure 9).
• Run the electrical cord through the secured Velcro straps of the
Controller Pouch – this will help keep the cord out of the way during
operation of the inversion table (Figure 10).
CAUTION: Be certain that all cords are AWAY and CLEAR of the
inversion table pivot points.
• Connect the electrical cord with the AC Adapter cord (Figure 10), then
plug the adapter into a 120 volt AC outlet.
7
FIGURE 10
!
FIGURE 9
To Next Page
Loading...
