EasyManua.ls Logo

TEFAL Cook4me EPC09 Series - Before Use; Initial Setup and Placement

TEFAL Cook4me EPC09 Series
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remove the appliance from its packaging and
read the instructions carefully before using the
product for the first time.
Install the appliance on a flat dry surface
that is not hot. Remove all the packaging,
stickers or dierent accessories inside and
outside the appliance.
To open the product, turn the open/
close handle on top of the lid, until
the marking is in line with the open
padlock.
CLEAN THE DIFFERENT
COMPONENTS
1
Cooking bowl
2
Metal lid
3
Valve cover
4
Condensation trap
5
Steam basket
6
Decompression ball
HOW TO
DISASSEMBLE
AND REASSEMBLE
THE LID
HOW TO DISASSEMBLE
THE METAL LID:
Grip the lid sub-assembly holding it by the seal,
and unscrew the central nut in an anti-clockwise
direction. Remove the nut then the lid.
PUTTING THE METAL LID
SUB-ASSEMBLY BACK IN TO
PLACE:
Grip the lid sub-assembly by the seal as shown
in the picture.
Line up the lid with the central axis and press
it flat against the sub-assembly.
Put the nut back on and turn it clockwise,
tightening it as far as it will go.
HOW TO TAKE THE VALVE COVER OFF:
Clasp the valve cover by its middle part (as shown) ;
Then turn it slightly to unclip it.
Clean the valve cover, paying special attention to the inside
(check that there is no left over food).
PUTTING THE VALVE COVER BACK:
Take the valve cover as shown in the picture
(gripping the middle).
Line up the interior circular shape with the three
hooks and then push so that the valve cover clips
on (you should hear a “click” sound).
The valve cover must be right up against
the inside of the lid.
ACCESSING THE DECOMPRESSION BALL:
Turn the ball cover, anti-clockwise, so the I marker is positioned on the
pictogram
. Lift the cover up. Remove the ball, and gently clean it, along
with its cover, with water and some washing-up liquid. Dry the ball using a
soft cloth, then put it back in position. Put the ball cover back in place, and
the marker
I in position . Lock it by turning the ball cover clockwise, so the
I marker is positioned on the pictogram
.
3 4 5
1 2
1
2 3 4
5
6
5
BEFORE USEBEFORE USE

Related product manuals