EasyManua.ls Logo

TEFAL OPTICORD PRESSING - Dry Ironing; Vertical Steam Ironing

TEFAL OPTICORD PRESSING
54 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
21
Use
Steam ironing
Set the iron temperature adjustment dial and the steam flow
adjustment dial (according to model) to the type of fabric to be
ironed (see table below).
The thermostat light comes on.
To obtain steam, press on the steam control button on the iron
handle (C).
The steam will stop when you release the button.
Start with the fabrics to be ironed at a low temperature and finish
with those which need higher temperatures (••• or Max).
To prime the steam circuit, either before using the iron for the first
time, or if you have not used the steam function for a few minutes,
press the steam control button (C) several times in a row, holding
the iron away from your clothes.This will enable any cold water to
be removed from the steam circuit.
For delicate fabrics, press the steam control button (on the handle of
the iron) intermittently to avoid possible water droplets appearing
with the steam.
If you are using starch, it should be sprayed onto the reverse side of
the fabric to be ironed.
Dry ironing
Do not press on the steam control button (C).
Vertical steam ironing
Set the iron temperature dial and the steam flow adjustment dial
(according to model) to the max. position.
Hang the garment on a coat hanger and hold the fabric slightly taut
with one hand.
Press repeatedly on the steam control button (C) (on the iron
handle) moving the iron from top to bottom (D).
The generator and the iron are
ready to iron when the steam
ready indicator light (according
to model) is lit and the iron
thermostat dial light has
gone out.
TYPE OF FABRIC
SETTING THE TEMPERATURE
DIAL
SETTING THE STEAM DIAL
(according to model)
Linen, Cotton
FFF
Wool, Silk, Viscose
FF
Synthetic
(Polyester,Acetate,Acrylic, Polyamide)
F
Mixed fibre fabrics : set the
ironing temperature to the
setting for the most delicate
fabric. Woollen garments : press
repeatedly on the steam control
button (C) to obtain short bursts
of steam, without placing the
iron on the garment itself.
This will avoid making the fabric
shiny.
As steam is very hot, never
attempt to remove creases from
a garment while it is being
worn, always hang garment on
a coat hanger.
For fabrics other than linen or
cotton, hold the iron a few
centimetres from the garment
to avoid burning the fabric.
EN
 )**',B$-31

Related product manuals