16
*depending on model
EN
TEFAL answers your questions
Problems Recommandations
I cannot close the
lid:
• Make sure the jaws are fully open before fitting the
lid onto the pot.
• Check good condition and correct position of the
seal.
If your pressure
cooker has been
heated without
any liquid in it:
•Have it checked at a TEFAL Approved Service Centre.
If the pressure in-
dicator does not
rise:
• This is normal for the first few minutes
• If the problem continues, check that:
- There is enough liquid inside the pan.
- The source of heat is high enough; if not, increase
the heat.
- The pressure selector is not turned to .
- The pressure cooker is closed properly.
- The control module is screwed in properly.
- The clamps must be in contact with the edge of
the lid.
- The seal for the lid is positioned correctly.
- The seal is clean and in good condition; change it
if required.
- Check the cleanness and the mobility of the pres-
sure indicator.
The pressure indi-
cator has lifted up
and no steam es-
capes from the re-
lease outlet during
cooking:
• Set the programme selector to :
- If no steam escapes, put your pressure cooker under
cold water to release the steam, then clean the ope-
rating valve and release outlet.
- If steam escapes, the pressure level has not been rea-
ched yet: set the selector back to the initial position.
If steam escapes
from around the
control module:
check:
• The control module is sufficiently screwed on.
• Good condition and correct installation of the seals
on the operating and safety valves.
To Next Page
Loading...
