Maintenance
You must rinse out the boiler after approximately
every 10 uses to maintain performance.
1 Check that the generator is cold and unplugged for more
than 2 hours, and that the removable water tank is empty.
2 Place your steam generator on the edge of your sink.
3 Unscrew the cord clip by turning a quarter turn to the left.
4 Using a coin, unscrew the boiler drain plug.
5 Holding your steam generator in a tilted position, and using a jug,
fill the boiler (in the base unit) with 1/4 litre of tap water.
6 Shake the base unit for a few moments and then empty it
completely over a sink or bucket.
To obtain the best result, we recommend
that this operation is done twice.
7 Important : before closing, make sure no water remains
in the boiler.
8 Replace and tighten up the boiler drain plug.
9 Put the cord clip back in place.
Tips for better ironing
• Use a vented ironing board with a large iron rest.
• Use tap water only. Do not use scented or softened water.
• If you use starch, it should be sprayed on the reverse of the fabric.
• Do not iron new garments without washing them first.
To Next Page
Loading...
