6766
EN
Problem Possible reasons Solutions
Intense release of
pressure from the
pressure limit valve.
The pressure limit valve is in
an incorrect position.
Carefully rotate/press the
pressure limit valve to make it
fall into place. Be careful of the
hot steam. Position yourself
safely and wear oven mitts.
Faulty pressure control
resulted in release of pressure.
Send the appliance to an
Approved Service Centre for
repair.
Continuous pressure
release from the
float valve.
Residue in the float valve.
a. Press continuously the
pressure release button
to remove the pressure
inside of the cooking pot.
It can take a few minutes
until the pressure is fully
released.
b. Let the appliance cool
down for at least 2 hours.
c. Clean and dry off the float
valve before restarting the
cooking.
The float valve is stuck.
a. Press continuously the
pressure release button
to remove the pressure
inside of the cooking pot.
It can take a few minutes
until the pressure is fully
released.
b. Let the appliance cool
down for at least 2 hours.
c.
Clean and dry off the float
valve before restarting the
cooking.
Steam leakage from lid.
The sealing gasket is not
properly installed.
Remove the sealing gasket,
clean it and reinstall it in the
correct position.
The sealing gasket is dirty.
Remove the sealing gasket,
clean it and reinstall it in the
correct position.
The sealing gasket is
damaged, or the edge of the
cooking pot is damaged.
Send the appliance to an
Approved Service Centre for
repair.
Problem Possible reasons Solutions
Food is uncooked
Solid/liquid ingredients ratio
is incorrect.
Try again by following
precisely the quantities of
the recipe.
No electricity from the power
supply.
Check your home electric
circuit.
E0 displayed on the
digital screen.
Pressure switch is faulty.
Send the appliance to an
Approved Service Centre for
repair.
E1 displayed on the
digital screen.
The temperature sensor
is faulty.
Send the appliance to an
Approved Service Centre for
repair.
E2 displayed on the
digital screen.
The lid is not properly
positioned for your cooking
program. Each program
requires a specific lid position.
Check and adjust the lid
position required by your
cooking program, refer to the
cooking programs table in
part 6 of this manual. Restart
your program once the lid
is correctly positioned. If
the issue remains, send the
appliance to an Approved
Service Center for repair.
To Next Page
Loading...
