• Do not vacuum large items that may clog and damage the air
inlet.
Depending on model:
• Do not use the power-brush on deep pile carpet, animal hair or
fringes.
• Switch to „Min/ECO“ to vacuum thick or delicate carpets and rugs
and fragile surfaces. Note: check regularly that the nozzle wheels
are clean.
• Switch to „BOOST“ for optimum performance on all types of very
dirty oors. Note: If the appliance sticks to the surface too much,
switch back to „Min/ECO“.
• Do not use your vacuum without a motor protection lter.
• Do not wash the dust collector components or the motor
protection lter in a dishwasher.
Battery safety instructions
• This unit contains batteries (Lithium Ion) which for safety
reasons are only accessible by a professional repairer. When the
battery is no longer able to hold the charge, the battery pack
(Lithium Ion) should be removed. To replace the batteries,
contact your nearest Approved Service Centre. Do not replace a
block of rechargeable batteries with non-rechargeable batteries.
To change the batteries, please contact an Approved Services
Centre.
• The batteries are designed for indoor use only. Never immerse
them in water. The batteries must be handled with care. Do not
put batteries in your mouth. Do not let batteries touch other
metal objects (rings, nails, screws, etc). You must take care not
to create short circuits in the batteries by inserting metal objects
at their ends. If a short circuit occurs, the battery temperature
may rise dangerously and can cause serious burns or even catch
re. If the batteries leak and in case of contact, do not rub your
eyes or any mucous membranes. Wash your hands and rinse your
eyes with clean water. If the discomfort persists, consult your
doctor.
• WARNING - The battery used in this appliance may present
risk of re or chemical burn if used incorrectly. It should not
be disassembled, short-circuited or stored at < 0°C and >
45°C or incinerated. Keep out of the reach of children. Do not
disassemble it or throw it in re.
• If the appliance is to be stored unused for a long period, the
batteries should be removed
Environment
In accordance with existing regulation, any end-of-life appliances
must be taken to an approved Service Centre which will take
responsibility for managing their disposal.
Let’s help protect the environment.
Your device is designed to work for many
years. But when you decide to replace it, don’t
forget to think about how you can help protect
the environment by allowing it to be reused,
recycled or recovered in some other way. Waste electrical
and electronic equipment may contain harmful substances
that can cause harm to the environment and human health.
This label indicates that this product must not be
disposed of with household waste. Take it to a collection
point, to the distributor when buying a new equivalent
product, or an approved service center for processing.
Before disposing of the device, remove the battery and dispose of it
in accordance with local laws and local arrangements. If you have
any questions, please contact your product dealer who can tell you
what to do.
PROBLEMS WITH YOUR APPLIANCE ?
Depending on model :
PROBLEMS POSSIBLE CAUSES SOLUTIONS
The charger becomes hot.
This is perfectly normal. The vacuum cleaner can
remain permanently connected to the charger
without any risk.
The charger is connected but your
appliance is not charging.
The charger is not properly connected to
the appliance or is faulty.
Check that the charger is properly connected
or contact an Approved Services Centre to
change the charger.
Your appliance stops during operation and
the light/s flash very quickly.
Your appliance may be overheating.
Stop the appliance and leave cool for at
least 1 hour.
The appliance has stopped after the charge
light ashed.
The appliance has lost its charge. Recharge the vacuum cleaner.
The power-brush is not working properly or
makes a noise.
The rotating brush or hose are obstructed.
Stop the vacuum and
clean the parts.
The brush is worn.
Contact an Approved Service Centre to
change the brush.
The belt is worn.
Contact an Approved Service Centre to
change the belt.
The power-brush stops during use of the
vacuum cleaner.
The heat safety device
has come on.
Stop the vacuum cleaner. Check that
nothing is obstructing the rotation of the
brush; if there is an obstruction, remove it
and clean the power-brush, then turn on
the vacuum cleaner.
Your vacuum cleaner suction is not working
properly or is making a whistling noise.
The tube or hose is partially blocked. Unblock them the tube/hose.
The dust collector is full. Empty it and clean it.
The dust collector is not properly tted.
Re-position it correctly.
The suction head is dirty. Remove the power-brush and clean it.
The foam motor protection
lter is full.
Clean it.
When charging the vacuum cleaner, the
light(s) ash very quickly or the red light
is on.
The correct charger is not being used or the
charger is faulty.
Talk to an Approved Service Centre to
change the charger.
The red LED on the product ashes
during use
The suction head brush is blocked.
Stop vacuuming and check that there is
nothing blocking the rotation of the brush.
The battery temperature is too high.
Leave the product to rest for 30minutes.
If the problem persists, replace the
battery.
The tube and/or suction head
connectors are dirty or damaged.
Clean the tube and suction head
connectors with a cloth.
The suction motor is not working.
Contact an Approved Service Centre to
have your appliance repaired.
The vacuum feels very sti/dicult to
push on carpet.
The vacuum is being used on a very
deep/long pile carpet.
Reduce the suction power using the
conrol panel to make it easier to push
the vacuum on long pile carpet. If this
doesn’t work, revert to using a non
motorised accessory such as the sofa
brush/crevice nozzle.
Please keep this user manual.
4 54 5
To Next Page
Loading...
Need help?
General
