Operating Instructions-2225 Service
6.
Plugged the power cord into the appropriate
power-source outlet.
Now turn on your oscilloscope by pressing in the
POWER button. Observe that the POWER-ON
indicator, located below the button, is lit.
REPACKAGING
If this instrument is shipped by commercial transpor-
tation, use the original packaging material. Unpack
the instrument carefully from the shipping container
to save the carton and packaging material for this
purpose.
If the original packaging is unfit for use or is not
available, repackage the instrument as follows:
1.
Obtain a corrugated cardboard shipping carton
having inside dimensions at least six inches
greater than the instrument dimensions and
having a carton test strength of at least
275
pounds.
2.
If the instrument is being shipped to a Tektronix
Service Center for repair or calibration, attach a
tag to the instrument showing the following:
owner of the instrument (with address), the
name of a person at your firm who may be
contacted if additional information is needed,
complete instrument type and serial number,
and a description of the service required.
3.
Wrap the instrument with polyethylene sheeting
or equivalent to protect the outside finish and
prevent entry of packing materials into the
instrument.
4.
Cushion the instrument on all sides by tightly
packing dunnage or urethane foam between the
carton and the instrument, allowing for three
inches of padding on each side (including top
and bottom).
5.
Seal the carton with shipping tape or with an
industrial stapler.
6.
Mark the address
of
the Tektronix Service
Center and your return address on the carton in
one or more prominent locations.
Scans
by
ARTEK
MEDLA
=r>
To Next Page
Loading...