13
6. After 4 minutes, an alarm will sound and
the oven will stop heating.
7. Turn the control dial to position .
8. Wait for about 20 minutes for the interior
of the oven to cool.
9. Any traces of dirt and excess water can
now be removed from the oven with the
damp cloth.
The Hydroclean
®
function takes place at a low
temperature. However, cooling times can
vary depending on the room temperature.
If a deeper clean is required after using the
Hydroclean
®
function, use neutral detergents
and non-abrasive sponges.
Do not open the oven until the cooling
phase is complete.
This is necessary for the Hydroclean
®
function to work properly.
Before touching the inside surface of the
oven, make sure that it has cooled
properly.