Teka HLC 847 C

15
EN
Teka Hydroclean
®
function
This function makes it easy to remove grease
and other food debris that may have stuck to
the sides of the oven.
For easier cleaning, do not allow dirt to
accumulate. Clean the oven frequently.
PROGRAMING THE TEKA HYDROCLEAN
®
FUNCTION
Always run the cycle on a cold oven. The
result could be affected and the varnish
damaged if it is run when the oven is too hot.
First remove the trays and all accessories
from the oven interior, including the tray
supports and telescopic guide rails.
To do this, follow the instructions in the
installation and maintenance guide
accompanying the oven.
1. With the oven cold, spread a cloth out on
the bottom of the oven.
2. Gently pour 200 ml of water into the
bottom of the oven cavity.
3. Turn the control dial to position .
4. Set the temperature to 90º C.
5. Program a duration of 4 minutes on the
timer.
6. After 4 minutes, an alarm will sound and
the oven will stop heating.
7. Turn the control dial to position .
8. Wait for about 20 minutes for the interior
of the oven to cool.
9. Any traces of dirt and excess water can
now be removed from the oven with the
damp cloth.
The Hydroclean
®
function takes place at a low
temperature. However, cooling times can
vary depending on the room temperature.
If a deeper clean is required after using the
Hydroclean
®
function, use neutral detergents
and non-abrasive sponges.
Do not pour water into a hot oven as this
can damage the enamel of the oven.
For best results, add a teaspoon of mild
washing up detergent to the glass of
water before pouring onto the cloth
Do not open the oven until the cooling
phase is complete.
This is necessary for the Hydroclean
®
function to work properly.
Before touching the inside surface of the
oven, make sure that it has cooled
properly.