Teka HLC Series User Manual

30
User’s Guide
Pyrolytic self-cleaning function
Function available in pyrolytic models HLC P.
WARNING
Before setting the pyrolytic cleaning cycle,
carefully read the safety instructions, which
you will find at the start of the Installation and
Maintenance guide.
This function allows you to carry out a pyro-
lytic cleaning cycle during which, due to the
2. Gently pour 200 ml of water into the bottom
of the oven cavity.
INFORMATION
For best results, add a teaspoon of mild
washing up detergent to the glass of water
before pouring onto the cloth.
3. Turn the control dial to the
position.
4. You will hear a beep indicating that the Teka
Hydroclean
®
cycle has started. The sym-
bol will flash slowly and the time remaining to
complete the cycle will appear on the display.
IMPORTANT
The duration of this cycle cannot be changed.
To stop the cycle before it is finished, turn
the control dial to the
position.
5. When the cycle is finished, the oven will turn
itself off, an alarm will sound and the
symbol will flash quickly.
IMPORTANT
Do not open the oven door until the Hydro-
clean
®
function is complete.
The cooling cycle is necessary for the func-
tion to work properly.
6. Touch any sensor with your fingertip to stop
the alarm and turn off the
symbol.
7. Turn the control dial to the
position.
8. Any traces of dirt and excess water can now
be removed from the oven with the damp
cloth.
The Hydroclean
®
function takes place at a low
temperature. However, cooling times can vary
depending on the room temperature.
WARNING
Before touching the inside surface of the
oven, make sure that it has cooled properly.
If a deeper clean is required after using the Hy-
droclean
®
function, use neutral detergents and
non-abrasive sponges.

Teka HLC Series Specifications

General

Brand	Teka
Model	HLC Series
Category	Oven
Language	English