Teka TBBQ 4100 G SS - User Manual

Questions and Answers

C
Corey HaleAug 16, 2025
Why is there excessive flare-up on my Teka Grill?
- J
  josephjohnsonAug 16, 2025
  Excessive flare-ups on your Teka Grill can occur for several reasons: * **Grilling fatty meats:** Grill fatty meats when the grids are cold and the knobs are on the “LOW” setting. If the flare-up continues, move the meats to the warming rack. * **Controls set to “HIGH”:** Ensure the knobs are turned to the “OFF” position before grilling. * **Spraying water on gas flames:** Avoid spraying water on gas flames. * **Hood closed while grilling:** Keep the hood up when grilling.
M
Mary PerkinsAug 18, 2025
What to do if Teka TBBQ 4100 G SS or side cooker will not light?
- G
  Gregg CoffeyAug 19, 2025
  If your Teka Grill or side cooker won't light, here are some potential causes and solutions: * **Ignition wire disconnected:** Reconnect the ignition wire to the electrical igniter/valve. * **Incorrect distance between ignition pin and burner:** Loosen the ignition pin, adjust the distance to between 3.96 mm and 4.75 mm (for the side burner), and then tighten it. * **Broken ignition wire:** Call Customer Service for a replacement. * **Dead battery:** Install a new battery. * **Incorrect battery polarity:** Check the battery polarity. Ensure the negative (-) side of the battery goes in first. * **Electrode tip not producing sparks:** Reinstall the electrode. * **No gas supplied:** Check the regulator valve and connection for leaks.
S
Sherri GouldAug 22, 2025
How to fix low heat with LP gas on Teka TBBQ 4100 G SS?
- T
  tyler01Aug 22, 2025
  The regulator assembly incorporates an excess flow device designed to supply the Teka grill with sufficient gas flow. Rapid changes in pressure can trigger the excess flow device, providing a low flame and low temperature. To resolve this: 1. Make sure all burners are “OFF.” 2. Open the tank valve and wait 5 minutes. 3. Light each burner, one at a time, following the lighting instructions.
A
Alexandra MorrisAug 25, 2025
Why does the burner on my Teka TBBQ 4100 G SS Grill keep blowing out?
- A
  andersonsamanthaAug 26, 2025
  If the burner on your Teka Grill blows out, consider these possible causes and solutions: * **Empty LP tank:** Refill the LP tank. * **Misaligned burner:** Install the burner correctly so that it aligns with the control valve. * **Insufficient gas supply:** Check the gas supply hose for leaks or knots and ensure it is providing sufficient gas.
J
Jason ConnerAug 27, 2025
Why is the heat low on my Teka TBBQ 4100 G SS when set to 'HIGH'?
- Z
  Zachary SalasAug 28, 2025
  If your Teka Grill has low heat even when set to “HIGH”, it might be due to: * **Blocked ports:** Clear any obstructions from the ports. * **Empty LP tank:** Refill the LP tank.
T
theresa68Aug 31, 2025
Why is my Teka Grill having excessive flare-ups?
- J
  Jessica PalmerAug 31, 2025
  If your Teka Grill experiences excessive flare-ups, try the following: * When grilling fatty meats, ensure the grids are cold, and the knobs are set to “LOW”. If flare-ups continue, move the meats to the warming rack. * Ensure the controls are turned to “OFF” before you begin grilling. * Never spray water on gas flames. * Keep the hood up while grilling.
T
Teresa RichardsSep 3, 2025
How to fix a Teka Grill that will not light?
- M
  Michelle JohnsonSep 3, 2025
  If your Teka Grill or side cooker won't light, here are a few things to check: * Ensure the ignition wire is securely connected to the electrical igniter/valve. Reconnect if necessary. * Verify the distance between the ignition pin and the burner is between 3.96 mm and 4.75 mm (for the side burner). Adjust and tighten if needed. * Install a new battery, ensuring correct polarity (the negative (-) side goes in first). * Check that the electrode is correctly installed and produces sparks at the burner port. Reinstall if necessary. * Confirm that gas is being supplied by checking the regulator valve and connections for leaks.
N
Nancy MooreSep 6, 2025
What to do if my Teka Grill burner blows out?
- S
  Sabrina Barnes MDSep 6, 2025
  If the burner of your Teka Grill blows out, consider these potential causes: * The LP tank may be empty. Refill it. * The burner might not be correctly aligned with the control valve. Ensure it is properly installed. * There might be an insufficient gas supply. Inspect the gas supply hose for leaks or knots.
T
Thomas FloresSep 9, 2025
Why does my Teka Grill have low heat on “HIGH”?
- K
  Kenneth CohenSep 9, 2025
  If your Teka Grill has low heat even when set to “HIGH”, try these solutions: * Check the ports for any obstructions and clear them. * Ensure the LP tank is not empty and refill if necessary.
N
nicholasmezaSep 12, 2025
What to do if Teka Grill has low heat with LP gas?
- D
  Darlene SmithSep 12, 2025
  If your Teka Grill is producing low heat with LP gas, it might be due to the propane regulator's excess flow device being triggered. To reset it: 1. Ensure all burners are turned “OFF”. 2. Open the tank valve and wait for 5 minutes. 3. Light each burner individually, following the standard lighting instructions.