8.2 Cleaning the Base Filter
— Ensure the dryer has cooled down after any recent operation.
— Unplug the appliance.
— Open the base filter cover, as illustrated below.
— Unscrew the two locking levers, rotating them towards each other.
— Completely clean the base filter using the same method as described in 8.1.
— Reinsert the base filter and re-screw the locking levers in place.
— Close the base filter flap, until it locks in position.
Warning! Never operate the dryer without the filters installed.
8.2 Cleaning the Heat Exchanger
If you frequently use your appliance, it is recommended to clean the heat exchanger
approximately once every two months. Be careful not to damage the air heat exchanger and
please use gloves.
Note:
The lint and fluff can easily be removed when first lightly dampened.
8.3 Empty the water container
Warning! After each use, the water container should be emptied.
— Hold and pull out the water container using two hands.
— Tilt the water container, pouring out the condensed water in to a sink.
— Re-insert the water container into the appliance.
Note:
If the container requires emptying during operation, the programme will pause and the
icon will flash on the display. Follow the process above to empty the container and
restart the programme by pressing the “Start/Pause” button.
Warning! — Do not drink the condenser water.
— Do not operate the dryer without the water container in place.
8.4 Error Alarms
To Next Page
Loading...
