2-582 910-3638-001 Revision B, October 2006
E3600 Messages Command Rejected Messages
E3680 Cmd Rej: No match on ACTNAME parameter during retrieve
Commands Used: all gateway screening retrieve commands
The entered GWS stop action set name (actname) was not found.
Recovery
Enter the command specifying the screening reference to show all action set name
identifiers, as well as other values for the screening reference.
E3681 Cmd Rej: Source and destination combination is not allowed
Commands Used: copy-gpl
GPLs can be copied only as follows:
• From the fixed disk on the active TDM to the removable cartridge
• From the removable cartridge to the fixed disk on the standby TDM
• From the active TDM to the standby TDM
• From the standby TDM to the removable cartridge
The active TDM cannot be the destination.
Recovery
Re-enter the copy-gpl command specifying the correct values for the sloc and
dloc parameters.
Refer to the Commands Manual for information about the copy-gpl
command.
Call your Customer Care Center if this error message appears again.
E3682 Cmd Rej: GWS and LNP must be ON before TLNP can be ON
Commands Used: chg-feat
You cannot turn on the Triggerless LNP feature before both the Gateway
Screening and the Local Number Portability features are turned on.
Recovery
1. Display the features in the database. Enter the rtrv-feat and the
rtrv-ctrl-feat command.
To Next Page
Loading...
