C Attach Rebounder Tube to Frame
1 Unfold rebounder tube
2 Make sure pin is positioned towards the front side
of the rebounder tube.
3-4 Place the hole on the skid bracket on top of pin on
rebounder tube.
1
4
2
3
1 Identify bungee with a double loop. Make sure this is on the bottom right side before you
begin attaching net to the frame
2 Attach the two top corner loops (one at a time) over the top corners of the frame
3 Attach the corner loop over the eye bolt on the bottom left side of the frame – same side
as Tekk
®
logo on the net
4 Attach the bungee with double loop over the eye bolt on the bottom right side of the
frame. NOTE: THIS BUNGEE WILL ALWAYS BE ATTACHED LAST AS IT IS LONGER.
D Attach Net to Frame
1
4
1
2
2
3
E Attach Bungees to Net
You received an extra bungee with hook in the box. You
will use this as a tool to attach the net to the frame. See
pics 1 & 2. We recommend using two people to attach
the net to the bungees as it is very tight. One person
pulls the net towards the frame and the other person
pulls the bungee hook towards the net.
1 Attach bungees on bottom tube to net
2 Attach bungees on top tube to net
3 Attach bungees on side tubes to net
2
1 For outdoor use, drive stakes into ground
through holes in the middle of each Tekk
®
Trainer leg. The Tekk
®
Trainer has friction
pads on the bottom of the legs for indoor
use. We recommend always anchoring
th e Tekk
®
Trainer for complete safety.
1
F Stake Tekk Trainer to Ground
To Next Page
Loading...