TEKNA TCK - Page 5

EM00136064 rev. 2.1
5
Display during Operation Display during Setting (MODE key)
Weekly
F
F
F
Mon
Lev Stop 12.01
Operating mode
• Weekly timer
Alarms and statuses
• Lev = Level alarm
• Flw = Flow alarm
• Mem = Memory alarm
FLOW
sensor
status
• Day of the week
Displays the quantity during
dosages
Pump status
• Empty = pump in start
• Stop = pump stationary
• Paus = pump in pause
Time
• Displays hours
and minutes
P01:START Mon
14.40 12.01
Operating mode
•
Displays in sequence:
programme number, activation
time, quantity, dosage time,
relay status.
• Day of the
wee
k
Time
• Displays hours and minutes
Paragraph 3 – Timed Dosage (Frequency signal input “TRIGGER” activated)
Programming Operation
+
-
-
-
-
+
-
+
-
+
-
Time
Quantity 100ml
Delay 0.01.50
interv. 0.01.50
PROG
Time
Time g.hh.mm
Time g.hh.mm
Configuration
Pump functions
Configuration
Pump functions
-
-
Trigger Mode
Pause Input Mode
-
Trigger Mode
-
Trigger Mode
Trigger Mode
N. Open
N. Open
N. Closed
Disable
Trigger Mode
After receipt of the TRIGGER signal set, the pump doses a quantity
that can be programmed in ml. It is possible to set a delay time before
the dosing (Delay) and the interval between subsequent dosings
(Interv.) as illustrated in the diagram:
By setting for example an Interval. time = 0, a system is obtained in
which the programmed quantity is dosed after each TRIGGER signal
(with any delay that has been set):
It is possible to start the dosing by pressing the + key, which, in
practice, simulates the Trigger signal.
The Trigger signal can be set to N. Open (it is activated when the
input passes from the open to the closed mode) or to N. Closed (it is
activated when the input passes from the closed to the open mode).
The Trigger signal is locked during dosing (its receipt is neither stored
nor managed).
The Pause (Remote input) input cannot be programmed and its
activation stops the dosing, while its further deactivation makes the
system wait again for the Trigger signal for a new dosing.
The dosage frequency can be modified while the pump is operating,
by pressing the
keys at the same time to increase the
frequency, or the
keys to decrease it.
Delay
Inter
v
.
Quantity
Trigger
Delay
Trigger
Ritardo
Release