117-0815-0024
GENERAL SAFETY RULES
PLEASE READ AND UNDERSTAND THESE SAFETY RULES BEFORE OPERATING ANY
OF THE ACCESSORY JAWS.
WARNING!The NOVA ACCESSORY JAWS ARE DESIGNED FOR USE ON
TEKNATOOL CHUCKS ONLY. THEY ARE NOT DESIGNED TO FIT AND CANNOT BE
USED WITH ANY OTHER CHUCK. TO DO SO COULD CAUSE A MALFUNCTION AND
RISK OF SERIOUS INJURY. IF YOU ARE UNSURE OF THE USE OR APPLICATION OF
ANY OF THESE ACCESSORY JAWS BEFORE USING CONTACT YOUR RESELLER OR
TEKNATOOL DIRECTLY.
IMPORTANT:READ VERY CAREFULLY THE SAFETY SECTION IN THE TEKNATOOL
CHUCK MANUAL BEFORE OPERATION AND FOLLOW CLOSELY THE SAFETY RULES
OUTLINES IN THIS JAW MANUAL.
CONSULT RELEVANT OPERATIONAL SECTIONS OF THE TEKNATOOL CHUCK MANUAL
BEFORE USING JAWS.
SOME SAFETY DIRECTIONS ARE PERTINENT ONLY TO A CERTAIN JAW SET. ANY
ADDITIONAL SAFETY INFORMATION IS LOCATED IN THE TEXT OF THE RELEVANT
ACCESSORY JAW IN THE PAGES FOLLOWING.
DANGER: THIS CHUCK IS CAPABLE OF CONTRIBUTING TO SERIOUS INJURY, AS
WITH ANY OTHER POWER TOOL ACCESSORY, IF USED IMPROPERLY ON THE LATHE.
Before using the Teknatool chuck and accessory jaws, read and understand the instruction
manuals. Read and understand also the lathe manual. If you do not have a manual, contact
the supplier of your lathe to obtain one before using the lathe and chuck.
User must be professionally trained to use chuck and accessory jaws. Vocational school
courses are recommended. As with any other chucking method, an extremely cautious and
sensible approach is necessary. With the Teknatool chuck it is not possible to give exact
directions as to the amount of tightening pressure required for work holding. Follow closely
strict guidelines in this manual for different jaw types for wood blank diameters length, and
turning speed.
To Next Page
Loading...