We would like this part in order to explain what is the use of:
Sens: adjust the sensitivity of the detector is the part that is used to. The sensitivity of the parameter value will be
so high. With the rise of precision that should be considered is the possibility that interference can bring.
Attention! High sensitivity also increases the probability of detection of mineral. Therefore, the detector sensitivity
should be determined by the condition of the land where the structure will be used. If you believe that you cannot
determine this, if you leave this value at 5.
Mod: the part where the detector operating mode is selected. The detector has 6 different working modes. The
mode of operation with the following sequence can be used for the purpose of writes.
1 – This mode of operation for general use. Mineral soils with sandy coastal area and less mineralized normal
water use for the appropriate operating mode. The highest detection range in this mode can be obtained.
2 - This mode of operation is the mode that is used to distinguish the voice. Fashion metal detection in the
detector in addition to worthless with the sound of the first cut.
Attention! In this mode the sound is cut in said detector unworthy of all perception. One important point that
needs to be known what kinds of metals the detector is worthless, he said.
3 - Operating Mode This mode of operation is suitable for use in areas of high mineral and stony. In this mode, the
mineral is considered by the detector to the level of a given level and this level is set. This mod should not be used
on mineral soils.
4 - This mode of operation very high mineral fields, and fields of broken brick in the pit to use the appropriate
operating mode. In this mode, the detector does not set the level of the mineral itself. The mineral level of the soil
according to the setting that you will do sets. Tune for it is performed. During this process the coil 50cm or more
from the ground up arrow while in the air is observed should be kept. Shows a DOWN ARROW, while the position
or job of the search coil should be placed under than 1-2 cm. When the setting is completed, the status signaling
into the ground if the setting should be repeated.
Attention! In this mode of operation the detector mode 1 according to the fashion of the distance is experiencing
a loss.
5 - This mode of operation very high mineral fields, and fields of broken brick in the pit to use the appropriate
operating mode. In this mode, the detector does not set the level of the mineral itself. The mineral level of the soil
according to the setting that you will do sets. During this process the coil 50cm or more from the ground up arrow
while in the air is observed should be kept. Shows a DOWN ARROW, while the position or job of the search coil
should be placed under than 1-2 cm. If you have a situation like on the ground signaling with the + button should
be increased if the level of the mineral in the ground if you have a situation like cutting the sound – level of the
mineral with the button should be reduced. This process removed up and back down the coil to each increase or
decrease should be lowered. When the setting is completed, return to the main display by pressing the tune
button.
Attention! In this mode of operation is due to the distance to the detector in iron and iron derivatives.
To Next Page
Loading...