EasyManua.ls Logo

Teknomotor ATC41-ISO20 - User Manual

Default Icon
49 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ATC41-ISO20 INSTRUCTION MANUAL
DOC.U.A.001.DOCX Rev.02 del 11/11/2019 2
ATC41-ISO20
INSTRUCTION
MANUAL
Practical guide to the correct use of
Automatic Tool Changer ISO20

Table of Contents

Questions and Answers

  • R
    richardsjasonAug 9, 2025
    Why is my Teknomotor ATC41-ISO20 vibrating excessively during machining?
    • A
      Amy RochaAug 9, 2025
      Excessive vibration during machining with Teknomotor Industrial Equipment can stem from several causes. It could be due to an unbalanced or incorrectly fitted tool, so ensure the tool is balanced and correctly fitted. High cutting parameters can also induce vibration, so adjust or reduce them. Check the inverter settings for any discrepancies. Finally, the tool might be too large or heavy for the machining operation; consider using smaller tools.
  • G
    Garrett AguirreAug 25, 2025
    What to do if Teknomotor Industrial Equipment electrospindle gets very hot and is stopped by the PTC thermistor signal?
    • J
      Jillian SnowAug 25, 2025
      If your Teknomotor Industrial Equipment's electrospindle overheats and is stopped by the PTC thermistor signal, several factors could be responsible. First, verify that the inverter parameters are correctly set according to the values on the device's plate. Also, machining speeds might be too low for the power requirement, or the cooling fan grill could be blocked, so inspect the cooling fan grill and clear any obstructions. If the cooling fan is broken, replace it.

Teknomotor ATC41-ISO20 Specifications

General IconGeneral
BrandTeknomotor
ModelATC41-ISO20
CategoryIndustrial Equipment
LanguageEnglish