Tektronix 114

TEST CONDITIONS
All Voltage Readings were obtained under the following conditions
unless otherwise noted on the specific diagrams:
Line Voltage
D c Voltmeter Impedance
117 volts
20,000 Ω /volt
Control Settings:
All VARIABLE controls
PERIOD
WIDTH
AMPLITUDE
TRIGGER switch
counterclockwise (CAL)
100 µ S
10 µS
+ 3 to 10V
LEADING EDGE
Voltage readings shown in blue on the schematics were obtained
with a 20,000 Ω /volt meter and in some cases show meter loading.
All voltages measured with respect to the outside shell of C283 unless
otherwise (*) indicated.
Voltage readings may vary somewhat between instruments due
to normal manufacturing tolerances and component characteristics.
Waveforms shown on the schematics were obtained from the c rt
of a Tektronix Type 547/1A1 Oscilloscope.