Tektronix 5103N

SECTION
1
SPECIF1CA TION
5103N
Change
information,
if any,
affecting
this section will be found
at
the rear of the manual.
Introduction
,
NOTE
The 5103N
Power
Supply/Amplifier
module is an inter-
connection unit
for the display
module and
plug-in units. It
is operated
with
a
display
module, and
comprises one-half
of the
5100-series
oscilloscope
mainframe. It
accepts
up
to
three plug-in
units and
provides
pre-amplification
for the
deflection signals.
The
center and
left plug-in
compartments
are connected
to the
vertical
deflection system,
and the
right plug-in
compartment
is
connected to the
horizontal
deflection system.
Electronic
switching between
the left
and
center plug-ins
allow a
multi-trace
vertical
display
(chopped and
alternate
time-sharing modes).
The unit also
contains
regulated
DC-voltage
supplies to
provide power to
the
instrument
system.
The following electrical characteristics
apply over
an
ambient
temperature range of
0°C
to
+50°C.
Many of
the
measurement
capabilities
of the
5100-
Series
Oscilloscope
are
determined by
the
choice of
display
modules
and plug-in
units.
The
following
electrical
characteristics
apply
to the
Power
Supply/
Amplifier
unit only,
unless
noted
otherwise.
For
display
modules
or plug-ins
only,
see the
specification
section
of the
manual for
that unit.
INSTRUMENT
OPTIONS
Option 1
An export
transformer
is
available for
the 5100-series
oscilloscopes, and can be installed
as
part
of
the instrument
when ordered, or it can be
installed
at
a
later time. This
transformer permits
operation from
100-volt,
110-volt,
120-volt, 200-volt, 220-volt, and 240-volt sources
with
power-line frequencies
of from
50 to 60
hertz
and 400
hertz. For further information on option
1,
see
your Tek-
tronix, Inc.,
catalog,
or
contact
your local Tektronix Field
Office or representative.
TABLE
1-1
ELECTRICAL CHARACTERISTICS
Characteristic
Performance Requirement Supplemental Information
Vertical and
Horizontal Amplifiers
Input Signal
Amplitude
(Differential Input)
50
millivolts per
displayed division, ver-
tical
and
horizontal.
Horizontal
Centering 0.5
division or less.
Bandwidth DC to
at least 2.5
megahertz.
X-Y Phase Difference
(Checked
with two plug-ins
of the
same type)
1°
or less to 100 kilohertz.
Sensitivity
Change
Accuracy
degrades
by up to
1% when
operated in split-screen storage.
1-1