FIGURE AND INDEX
NUMBERS
Items in this section are referenced
by figure and index numbers to the illustrations
which appear on the
pullout pages immediately following the Diagrams section of this
instruction manual.
INDENTATION SYSTEM
This mechanical parts list is indented to indicate
item relationships. Following is an
example of
the indentation system used in the Description
column.
Assembly and
/or
Component
Detail Part of Assembly
and/or Component
mounting hardware for
Detail Part
Parts of Detail Part
mounting hardware for Parts of Detail
Part
mounting hardware for Assembly and/or Component
Mounting hardware always appears in the same indentation
as
the item it mounts,
while the detail parts are indented to the right. Indented items are
part
of, and
included
with, the next higher indentation.
Mounting hardware must be purchased separately, unless
otherwise specified.
PARTS ORDERING INFORMATION
Replacement parts
are available from or through your local
Tektronix,
Inc.
Field Office
or
representative.
Changes to
Tektronix
instruments are sometimes made to
accommodate improved
components as
they become available,
and
to give
you
the benefit of the latest
circuit
improvements
developed in
our
engineering department. It is therefore
important, when
ordering
parts, to include the following information in your order: Part number,
instru-
ment type or
number, serial or model number, and modification
number
if
applicable.
If a
part you have ordered has been replaced
with
a new
or improved part, your
local Tektronix,
Inc. Field
Office
or
representative will contact
you
concerning any change
in part
number.
Change
information, if any, is located at
the rear of this manual.
ABBREVIATIONS AND
SYMBOLS
For
an explanation
of the abbreviations and symbols used
in this section, please
refer
to
the
page
immediately
preceding
the
Electrical Parts List in this
instruction manual.
To Next Page
Loading...
