Commands Listed in Alphabetical Order
CURSor:VBArs
:DELTa? (Query Only)
Returns the horizontal difference between the two v ertical bar cursors. The units
are specified by the CURSor:VBArs:UNIts command.
This is equivalent to watching the cursor readout in the display while using the
appropriate cursor mode.
Group
Cursor
Syntax
CURSor:VBArs:DELTa?
Related Commands
CURSor:VBArs:UNIts
Returns
<NR3>
Examples
CURSOR:VBARS:DELTA? might return :CUR SOR:VBARS:DELTa 1.0640E+00
indicating that the time between the vertical bar cursors is 1.064 s.
CURSor:VBArs:HPOS<x>? (Query Only)
Returns the horizontal value of the specified vertical bar ticks for cursor <x>.
Group
Cursor
Syntax
CURSor:VBArs:HPOS<x>?
Related Commands
CURSor:VBArs:UNIts
Arguments
<x> specifies the cursor. Valid values are 1 and 2.
Returns
<NR3> indicates the value of one of the tics. The u nits are specifi ed by the
CURSor:VBArs:UNIts command.
Examples
CURSor:VBArs:HPOS2? might return CURSOR:VBARS:HPOS2 100E-3,
indicating that the value of one vertical bar tick.
2-11 6 MSO2000B, DPO2000B, MSO2000 and DPO2000 Series O scilloscopes Programmer Manual
To Next Page
Loading...
