Tektronix MSO2000B Series Programmer's Manual

Commands Listed in Alphabetical Order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:BUS:B<x>:RS232 C:TX:DATa:VALue
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:RS232C:TX:DATa:VALue?
SEARCH:SEARC
H<x>:TRIGger:A:BUS:B<x>:SPI:CONDition
Sets or returns the search condition for a SPI trigger search. SEARCH<x> is the
search number and
B<x> is the bus number.
Conditions
This command requires a DPO2EMBD application module.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:SPI:CONDition
{SS|MISO|MOSI|MISOMOSI}
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:SPI:CONDition?
Arguments
SS specifies a search based on the Slave Selection condition.
MISO specifies a search based on the Master-In Slave-Out condition.
MOSI specifies a search based on the Master-Ou
t Slave-In condition.
MISOMOSI specifies a search based on the Master-In Slave-Out and Master-Out
Slave-In conditions.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:SPI:DATa{:MISO|:IN}:VALue
Sets or returns the binary data string for an SPI trigger search if the search
condition is MISO or MISOMOSI.
SEARCH<x> is the search number and B<x>
is the bus number.
Conditions
This command requires a DPO2EMBD application module.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:SPI:DATa{:MISO|:IN}:
VALue < bin>
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:SPI:DATa{:MISO|:IN}:
VALue?
Arguments
<bin> is the data string in binary format.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-261

Tektronix MSO2000B Series Specifications

General

Analog Channels	2 or 4
Vertical Resolution	8 bits
Digital Channels	16
Waveform Capture Rate	5, 000 wfms/s
Display	7-inch WVGA (800 x 480) color TFT LCD
Trigger Types	Edge, Pulse Width, Logic, Video
Serial Bus Analysis	I2C, SPI, CAN, LIN, RS-232/422/485/UART
Probe Interface	TekVPI
Connectivity	USB 2.0
Power Supply	100 to 240 VAC
Dimensions	368 mm
Sample Rate	1 GS/s (2 GS/s with interleaving)
Record Length	1 M points (standard), up to 10 M points (optional)