Tektronix MSO2000B Series

Commands Listed in Alphabetical Order
TRIGger:A:BU
S:B<x>:LIN:IDentifier:VALue
Sets or returns the binary address string used for LIN trigger if the trigger
condition is ID or IDANDDATA.
Conditions
This command requires a DPO2AUTO application m odule.
Group
Bus
Syntax
TRIGger:A:BUS:B<x>:LIN:ID entifier:VALue <QString>
TRIGger:A:BUS:B<x>:LIN:ID entifier:VALue?
Arguments
<QString> is the binary address string used for LIN trigger if the trigger
condition is ID or IDANDDATA.
Examples
TRIGGER:A:BUS:B1:LIN:IDEN TIFIER:VALUE "110010" sets the identifier
value to 110010.
TRIGGER:A:BUS:B1:LIN:IDEN TIFIER:VALUE? might return
TRIGGER:A:BUS:B1:LIN:IDEN TIFIER:VALUE "XXXXXX" indicating that the
identifier value is XXXXXX.
TRIGger:A:BUS:B<x>:PARallel:VALue
Sets o
r returns the binary data string to be used for a parallel trigger. Applies to
bus <x>, where x is the bus number.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:PARall el:VALue <QString>
TRIGger:A:BUS:B<x>:PARall el:VALue?
Arguments
<QString> is the binary data string.
TRIGger:A:BUS:B<x>:RS232C:CONDition
Sets or returns the condition for a RS232C trigger, where x is the bus number.
Conditions
This command requires a DPO2COMP application module.
2-308 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual