Tektronix TDS 520A - Page 118

Command Descriptions
2–100
TDS Family Oscilloscope Programmer Manual


  

 selects functional, memory, and register tests.
DIAg:SELect:DISplay (No Query Form)
Selects the display system test sequence that will be run when the DIAg:STATE
EXECUte command is sent. This command is equivalent to setting Area in the
Utility menu when System is set to Diag/Err.
Calibration and Diagnostic
 


  

 selects functional, memory, and register tests.
DIAg:SELect:FPAnel (No Query Form)
Selects the front-panel test sequence that will be run when the DIAg:STATE
EXECUte command is sent. This command is equivalent to setting Area in the
Utility menu when System is set to Diag/Err.
Calibration and Diagnostic
 


  


 selects self diagnostic tests.
Arguments
Group
Syntax
Arguments
Group
Syntax
Arguments