Need help?Do you have a question about the Tektronix TDS Series and is the answer not in the manual?
General| Vertical Resolution | 8 bits |
|---|---|
| Input Coupling | AC, DC, GND |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Sample Rate | Up to 5 GS/s (depending on model) |
| Number of Channels | 2 or 4 |
| Record Length | Up to 10, 000 points (depending on model) |
| Display Type | Color LCD |
| Trigger Modes | Edge, Pulse Width, Video |
| Connectivity | GPIB, USB |
| Input Impedance | 1 MΩ |
| Power Requirements | 100-240 VAC, 50/60 Hz |
Summarizes the type of programming information contained in each major section of this manual.
Describes how to physically connect the oscilloscope to a controller and set the appropriate front panel controls.
Describes the structure and content of messages sent to the digitizing oscilloscope for commands and queries.
Explains how header mnemonics specify a range of mnemonics for commands.
Commands that affect waveform acquisition, controlling mode, averaging, and enveloping.
Commands that control graticule style, displayed intensities, and clear menus.
Sets or queries the acquisition mode of the digitizing oscilloscope.
Returns all current cursor settings, including type and position.
Explains the system of status registers like SESR and SBR, and enable registers like DESER, ESER, SRER.
Discusses methods like *WAI, BUSY?, *OPC, *OPC? for synchronizing programs.
Provides instructions on compiling and linking example programs written in Microsoft QuickBASIC and QuickC.
Acronym for General Purpose Interface Bus, a communications interface system.
To Next Page