Need help?Do you have a question about the Tektronix TDS 2012 and is the answer not in the manual?
General| Brand | Tektronix |
|---|---|
| Model | TDS 2012 |
| Category | Test Equipment |
| Language | English |
Steps to configure and print the oscilloscope screen display.
How to recall factory settings to restore the oscilloscope to its default configuration.
Function to automatically analyze and adjust settings for the dominant input signal.
Knobs used to adjust the vertical scales (volts per division) for CH1 and CH2 traces.
Knob to adjust the horizontal time scale (seconds per division) of the display.
Controls for moving signals vertically (channel position) and horizontally (time reference).
Overview of the oscilloscope's integrated help system and navigation methods.
Button to control continuous waveform acquisition or to stop data acquisition.
Button to acquire a single waveform and then stop, or to acquire another waveform.
Activates menu for focusing on specific waveform sections using windowing techniques.
Function to save and recall oscilloscope setups and waveforms.
Accesses automatic measurements for waveform parameters like frequency and amplitude.
Brings up a softkey menu for waveform acquisition settings.
Details on setting up edge triggering based on signal slope and trigger threshold.
Configuration for triggering on NTSC, PAL, or SECAM standard video signals.
Settings for triggering on aberrant pulses based on pulse width and polarity.
Controls for setting trigger level, midpoint, forcing acquisition, and viewing trigger signal.
To Next Page