tds2012_oscilloscope_guide.doc 11/18
Table 4 Save/Recall button Setups options
Table 5 Save/Recall button Waveforms options
2) Push the MEASURE button to access automatic measurements. Each of the five softkeys is
available to have a measurement source and type defined. For example, pressing the top
softkey will bring up a “Measure 1” softkey submenu with softkeys: <Source> which allows
the user to toggle between choices of CH1 and CH2, <Type> which allows the user to
cycle through the eleven types of measurements shown in Table 6, and <Back> which
returns you to the top “MEASURE” softkey menu. Pressing the second softkey down brings
up a “Measure 2” menu and so forth through the bottom softkey with the “Measure 5” menu.
Key Points: The waveform channel must be on (displayed) to make a measurement.
Automated measurements cannot be taken on reference or math waveforms, or while using
XY or scan mode. The measurements update about two times per second.
Dr. Montoya Rev. 3/16/09
To Next Page
Loading...
