Tektronix TDS 520A - Page 241

Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–223
 selects AC trigger coupling (not on TDS 684A & 7XXA).
 selects DC trigger coupling.
 coupling removes the high frequency components of the DC signal
(not on the TDS 684A & 7XXA).
 coupling removes the low frequency components of the AC signal
(not on the TDS 684A & 7XXA).
  coupling sets the delayed trigger coupling to match the setting on
the main trigger (TDS 684A & 7XXA only).
  selects DC low sensitivity.
 
sets the delay trigger to DC coupling.

might return  for the delayed trigger coupling.
TRIGger:DELay:EDGE:SLOpe
Selects either a rising or falling edge for the delayed trigger. This command is
equivalent to selecting Slope in the Delayed Trig menu.
Trigger
 ! "  #  $
 !

!






 

 specifies to trigger on the falling or negative edge of a signal.
 specifies to trigger on the rising or positive edge of a signal.
Arguments
Examples
Group
Syntax
Arguments