TELECO AUTOMATION TVPLD868C80TT3 User Manual

13
2.2
Working time conguration (necessary if 7/42 channel transmitters are used)
Attention: the following procedure is necessary when using 7/42 channel transmitters (type C).
P1
*
10x
Command a
manoeuvre using
a memorized
transmitter or
by means of the
wired input.
Press P1 again or wait
25 seconds to quit
the procedure without
saving.
Note: this automatic cycle can be stopped with any
command. If working time is exceeded (90 s), the control
unit stops and emits an intermittent sound until any button
is pressed.
(>3 s)
...
intermittent sound
complete
closing
complete
opening
LM ashes
...
complete
opening
...
* The buzzer will make a beep each press. No more than a second should pass between one press to another one.stopped.
2.3
Radio codes deletion
TYPE OF DELETION
P1
SINGLE RADIO CODE
*
5x
Press the button of the transmitter
relative to the code to delete
Press 5 times the button P1 and keep it pressed. The buzzer emits an intermittent sound. Press the button of the transmitter relative to
the code to be deleted within 10 seconds. Successful deletion is indicated by a continuous sound of the buzzer.
ALL THE RADIO CODES
*
6x
Press 6 times the button P1 and keep it pressed for 10 seconds. The buzzer emits a fast intermittent sound. Release when the sound
becomes continuous.
keep it pressed
...
(10 s)
continuous
sound
...
intermittent
sound
P1
EN
P1
Press the button P1 10 times and keep it pressed for 3 seconds.
The buzzer emits an intermittent sound.
continuous
sound

TELECO AUTOMATION TVPLD868C80TT3 Specifications

General

Brand	TELECO AUTOMATION
Model	TVPLD868C80TT3
Category	Control Unit
Language	English