14
3x
Remote deletion of a radio code
Note: P3 button is located inside the transmitter. The added radio code will have the same functions of
the code used for the memorization. This procedure is compatible with any type of transmitter.
Press the button P3 of the memorized transmitter. The buzzer emits a
continuous sound. Press the button relative to a memorized code. The sound
stops for 1 second then it starts again. Press the button relative to the new
code. The memorization is indicated by an intermittent sound of the buzzer.
...
P3
< 5 s
intermittent
sound
To delete
1 s
...
P3
New
< 5 s
continuous
sound
Memorized
< 5 s
continuous
sound
Memorized
Memorized
Note: P3 button is located inside the transmitter.
Press 3 times the button P3 of the memorized transmitter. The buzzer emits a
slow intermittent sound. Press the button relative to the code to delete within
5 seconds. The buzzer will stop sounding.
2.4
2.5
Remote memorization of further radio codes
WIND sensor
3.1
The anemometer (ANEM4) detects wind speed, which the control unit compares with the threshold set through DIPs 3-4 (see table).
The control unit is only compatible with anemometers generating 4 pulses per rev.
ACTIVE ALARM when Once ACTIVE ALARM DEACTIVATED ALARM when
The measured speed is higher then
the set threshold (see the table).
The control unit moves the louvres to the 50% of complete
opening and it doesn’t execute any command. LA ashes.
The sensor measures a speed lower than
the set threshold for at least 30 seconds.
DIP3 DIP4 Km/h
OFF OFF 40
OFF ON 50
ON OFF 60
ON ON 70
W
I
N
D
Alarm priority
HIGH
LA ashes
EN
Factory setting
ACTIVATED
To Next Page
Loading...
Need help?
General