PROTECTION
The Gorilla has four protection circuits.
If the maximum temperature is reached, the amplifiers are switched o to protect from
damage. Additionally the red protection led on the front will be enabled.
Also if a critical electrical failure or high frequency signal (like microphone feedback) is detected,
the amplifiers are shut down immediately and the red protection led on the front will be enabled.
In this case, unplug the power cord, wait for the back panel cool down and red light go o
(usually 3 minutes), plug the power cord and power on the Gorilla.
The Gorilla should resume normal operation. If not, please contact Telegrapher Loudspeakers.
To Next Page
Loading...