Installation Instructions
TH-3070-CTL
TH-3070-CTS
TH-3070-CTLW
TH-3070-CTSW
Component Checklist
Ceiling Tilt Short Mount / Ceiling Tilt Long Mount
Mounting
Cover
Horizontal Rail
M6/M8
Spacer (x4 each)
2mm/2.5mm/3mm
5mm/8mm Allen Key
M10 Coach
Bolt (x4)
Nylon
Anchor (x4)
HARDWARE
Display Mounting
Screws (x4 each)
M6x16mm/30mm/45mm
M8x16mm/30mm/50mm
Tools Required:
• Power Drill
• 7mm(0.25”) Drill Bit
• 12mm(0.5”) Masonry Drill Bit
• Phillips head screw driver
• 17mm(0.7”) Socket Wrench or Shifter
Mounting
Bracket (x2)
Pole
Assembly
Ceiling Cover
! IMPORTANT - Install Telehook Ceiling Mount as per installation instruction.
! This product supports a maximum load of 65kg (143lbs.).
! This product has a universal mounting hole pattern that suits a broad range of TV’s:
From 200-800mm in width and 200-500mm in height.
! The manufacturer accepts no responsibility for incorrect installation.
IMPORTANT INFORMATION:
Step 1. Check Components
Check you have received against the component checklist and hardware above.
Step 2. Install Mounting Plate to the ceiling
Using the Mounting Plate as a template, mark and drill 4 holes.
NOTE: Drilled hole sizes,
For Masonry Ceiling, Ø12mm (0.5”) and 70mm (2.75”) deep.
For Timber Ceiling, Ø7mm (0.75”).
Masonry Ceiling
Timber Ceiling
Drilled Holes
Nylon Anchor
Mounting Plate
M10 Washer
Coach Screw
Step 3. Install Mounting Cover
PUSH
Pole Assembly
Mounting Cover
Step 4. Attach Pole Assembly to Base Plate
Remove the three set
screws using the supplied
3mm Allen Key.
Set Screws
INSERT
Insert the three set screws
using the supplied 3mm
Allen Key to secure.
4A 4B 4C
Pole Assembly
Step 5. Position Mounting Cover
PUSH
Mounting
Cover
Mounting
Plate
Bracket Locking
Plate (x2)
M8x15mm
Screw (x2)
Cable
Clip (x2)
M4x12mm
Screw (x2)
Clamp Cover
Bottom
Clamp Cover
Middle
Clamp Cover
Side (x2)
Head Clamp
Assembly
Tightening Tool
M6/M8/M10
Washer (x4 each)
OR
M10x30
Screw
M10
Washer
To Next Page
Need help?
General