Sweep Select Control
See firures 3-C and 3-D
This option board is used in conjunction with sweepers incorporating pattern
preselect, such as the Telemark XY Sweep with the optional Sweep Select
Module. Switches S3 - S6 allow four sweep patterns (relay closesures on the
Sweep Select Control PCB, K5 - K8) to be married to any of the four or six pockets
controlled by the indexer. Push the DIP switch “ON” once for each of the pockets.
EACH INDEXING POSITION (POCKET) MUST HAVE ONLY ONE
SWEEP PATTERN SELECTED. SEE FIGURE 3-D
Four Pocket Sources:
Push the DIP switch ON to connect sweep pattern to connect sweep pattern to
pocket, ie. (S3) with all switches on gives you pattern (1) on all pockets. Only one
pattern per pocket is allowed. If pocket (1) is selected on S3 it cannot be selected
on S4, S5, or S6.
3-4 INSTALLATION
Telemark 376/379 Crucible Indexer
Figure 3-C
Crucible
Indexer Main
PCB
To Next Page
Loading...