Telematrix 3100LBY - Programming; To Program Store, Flash, and Pause; Storing a Number into Memory; Keys-Store

3100 SERIES USER GUIDE www.telematrix.net 7
5. Press FLASH.
6. Exit programming by hanging up the handset.
To program PAUSE follow the above sets—do the
following:
3. Programming PAUSE by pressing “1” for
1.0s, “2” for 2.0 s, and so on.
STORING PAUSE/REDIAL INTO
MEMORYPAUSE
If you are using your telephone anywhere that
requires an access code for outside calls, you may
need to add a PAUSE to the number to allow time
for the outside line to connect. You can enter an
many pauses as needed.
Note: A PAUSE or FLASH programmed into memory
counts as one digit when storing a number.
1. Lift the handset.
2. Press the STORE key.
3. Enter the required access code (8 or 9)
using the dial pad.
4. Press the PAUSE key.
5. Enter the digits to be stored using the
numeric dial pad.
6. Press the desired memory location wherein
the number is to be stored.
7. If additional numbers are to be stored,
repeat steps 3 through 7.
8. Hang up the handset.
(Does not apply to non-memory key telephones.)
FLASH HOOK FUNCTIONFLASH
The FLASH function is used to access PBX features
or Telco line features such as Call Waiting. The
FLASH function is a 600 mS timed line break. If the
FLASH function will be used often, store the feature
into memory located for easy access as follows:
1. Lift the handset then press the STORE key.
2. Press the FLASH key.
3. Press the memory location wherein the
FLASH is to be stored.
4. Hang up the handset.
Programming
The telephone set must be connected to the PBX
in order to program it.
TO PROGRAM STORE, FLASH, AND PAUSE
Some of these programming keys are located
under the faceplate and plastic overlay (PVC
sheet). Begin by lifting up the faceplate and plastic
overlay using either a paperclip or sharp pointer.
STORING A NUMBER INTO MEMORY
KEYSSTORE
Each location can store up to 32 digits in tone
mode.
Note: A PAUSE or FLASH programmed into memory
counts as one digit when storing a number.
1. Lift the handset.
2. Press the STORE key.
3. Enter the number to be stored using the
numeric dial pad.
4. Press the desired memory location wherein
the number is to be stored.
5. If additional numbers are to be stored,
repeat steps 3 through 5.
6. Hang up the handset.
(Does not apply to non-memory key telephones.)
PROGRAMMING FLASH TIMING AND
PAUSE TIMING
FLASH timing options are 100 mS through
1000 mS, programmable in 100 mS increments.
The default FLASH timing is 600 mS.
PAUSE timing options are 1.0 s through 5.0 s. The
default PAUSE timing is 3.6 s.
1. Lift the handset.
2. Press the STORE key once.
3. Dial from the keypad “1” for 100 mS, “2” for
200 mS, and so on.
4. Press the STORE key once.