• "Trunk Call ring": It is ring and ringback tone for incoming trunk calls.
• "Secondary dial tone": It is tone when a call is hold.
• "Multiple entry": It is tone when using multiple-entry services like changing status of
several room at once.
• "Multiple hold": It is tone when holding multiple calls on.
• "Reminder service": It is tone when reminder service is active.
• "Campon": It is tone for camped calls.
ANNOUNCEMENTS
The PX24U/PX24M Hybrid IP PBX system provides up to 100 different
announcements (or system messages), each of them with maximum duration of 10
minutes.
Some of these messages are used for predefined applications such as:
• Auto-attendant scenario
• Music on hold
• Music on park
• Wake up call
• Voice Mail (VMail) scenario
"Wav" wave files to be transferred from PC to the system should be 16 bits, 8 kHz,
mono in Windows waveform audio format (wave).
• Message-00 Welcome1: First greeting message in Auto-attendant applications
• Message-01 WelcomeAlt: Alternative greeting message (perhaps in another
language)
• Message-02 Busy: Busy message instead of the busy tone, caller can dial a new
number, Applicable only for DC loop trunks if welcome message is played
• Message-03 BusyAlt: Alternative busy message (perhaps in another language), caller
can dial a new number, Applicable only for DC loop trunks if welcomeAlt message is
played
• Message-04 Alerting: Alerting message instead of an alerting (ringback) tone
• Message-05 AlertingAlt: Alternative alerting message (perhaps in another language)
• Message-06 AlertingIni: Alerting message for incoming calls through DID trunks
• Message-07 Reminder: Reminder (wake-up) call message
• Message-08 Hold: Message (or music) on hold, played repatedly
• Message-09 VmailSend: Voice Mailbox greeting message
• Message-10 VmailSendAlt: Alternative Voice Mailbox greeting message (perhaps in
another language)
• Message-11 VmailReceive: Voice Mailbox reveice message (when mailbox is
accessed to listen left messages)
• Message-12 VmailPending: Notification message when there are pending Voice
Mails in the mailbox
• Message-13 Park: Message (or music) on park, played repatedly
• Message-14 Welcome2: Second greeting message in Auto-attendant applications
• Message-15 Welcome3: Third greeting message in Auto-attendant applications
• Message-16 VmailQuotaFull: Notification message when when personal Voice
Mailbox is full (out of quota)
• Message-17 CamponToRoute: Notification message played when all ports in route
are busy and the call is waiting for an outgoing available port.
• Message-18 NoAnswer: If B party do not answer, caller can dial a new number,
applicable only for DC loop trunks if welcome message is played
• Message-19 NoAnswerAlt:If B party do not answer, caller can dial a new number,
applicable only for DC loop trunks if welcomeAlt message is played
The remaining system messages are like ready-to-use resources. Using routing criteria
tables, callers may be routed to these system messages. System administrators may
decide on criteria when to play a system message. Some typical applications may be:
• dialing of a non-existing code,
• dialing of a vacant/unallocated number,
• fault or congestion in certain direction,
• restriction of use of services,
18
To Next Page
Loading...